Kafuter K-9111 Repair Epoxy Putty/Epoxy Adhesive for Iron Casting

Kafuter K-9111 Repair Epoxy Putty/Epoxy Adhesive for Iron Casting

Main Characteristics:

K-9111 is t wo parts, gel formulation, abrasion and corrosion resistant, good mechanical properties, using in the nodular iron and grey iron castings.

Typical Properties:

Applications:

Mainly apply in filling the air holes and sand holes, sealing the cracks, also, can patch not-structural defects.

Directions:

1.Surface Cleaning:

Remove the oil and grease from the surface, also should be abrasived and polished.

2. Mixing

Two-part, please mix and forge the two parts by equal ratio. It will become gel-formulation at the low temperature, it can change into soft gel heating by the heating producer.

Notice: Do not heat with the open-fire

After 24 h room cure, it can put into use.

3.Coating

First, coating the surfaces with some glue, and then push and repeat coating the surface until it exhaust the air and fully fill the gap.

4.Curing

When the room temperature is lower than 10 °C, and after 1-2 h room cure, use heat producer heating for 3-4 hour bewteen 80 °C, the heating producer between the parts should keep a distance of 300-400mm. and the small-area fittings can be put into the oven for heating below 80 °C.

(Heat Producer: infra-red lamp, electric stove, and other heating sources, not use the open-fire)

5 . Post-Processing

After cured some time, it can be processed by ordinary ways, and wait for 18 hour, it can use the machine for processing.

Packing :500g/pairs