High quality Resists moisture Double Components Adhesives Epoxy resin AB glue Floor Coating supplier floor adhesive

Epoxy resin AB adhesive is a high-strength, fast adhesive composed of two components: a epoxy resin and b curing agent. Mixing these two components together in a certain proportion will produce a very strong adhesive force that can quickly bond various materials together.

1.Original product Feature

Deep Cast Clear Casting Resin for River Tables DIY Crafts&Jewelry: The mixed resin can be readily pigmented by the addition of any resin pigments sold in our online store. It can then be poured into a mould, made of plastic or silicone rubber. Moulding can be carried out by gravity or under vacuum. River Tables: Excellent for River,Live-edge& Wood Tables. Whatever,the emperature should be between 18-25ºC with humidity level below 70%. A 2:1 mix will provide a hard casting suitable for manufacture of fancy shapes, decorative items etc. Once the resin is mixed and poured into the mould gently pass warm air from a heat gun or hair dryer on slowest speed setting,this will assist in removal of any bubbles generated during mixing.

OUR 2:1 FORMULA IS EASY TO MEASURE & EVEN EASIER TO POUR!
DIRECTIONS FOR USE:
Step 1: The ideal working temperature is around 77°F. Best results can be obtained at temperatures between 70°F and 85°F, in a clean, dry, dust-free environment. Avoid working in high humidity. We recommend using this product on a leveled and flat work surface.
Step 2: Measure product in accordance with your intended use. Prepare 2 parts Base Resin to 1 part Curing Agent by liquid volume.
Pour the Curing Agent first and then the Base Resin into a clean, smooth-sided container large enough to hold all the liquid and allow room for mixing.
Step 3: The material must be mixed thoroughly for at least 6-8 minutes. Be sure to scrape the container sides, bottom, and corners as you mix. Be careful not to whip excessive air into the mixture. If mixing a gallon, use a power mixer set to “hand speed.” For smaller quantities, use stir sticks. Do not mix more than a gallon. Pour into a new, clean container and mix for an additional minute.
Step 4: Pour the mixed resin onto the surface and distribute evenly with a squeegee or gloved hand. Continue to pour remaining material to achieve the desired thickness, allowing the resin to flow evenly over the project’s sides. Resin can be poured up to 2” thick per pour, and up to 4” depending on the volume of the pour.
Step 5: Use a heat source such as a heat gun to remove any bubbles by adding a small amount of heat to the surrounding area. The bubble will rise to the surface and pop.
Step 6: If you are going to make a second pour, the first pour should still be slightly sticky. Once the second pour is made,
bubbles may once again need to be removed. Material will feel hard after 48-72 hours, but full cure and maximum hardness can require up to 7 days, depending upon the temperature.
PRO TIP: If you wish to apply paper decals or other objects under the surface, those objects need to be bonded to the surface either with Epoxy or craft glue. Some wood may take the material well in a single coat; however, many types of wood require a seal coat to prevent air bubbles from rising out of the wood and ruining the surface. Older, more porous pieces of wood may contain both air and moisture that can contaminate the finish. In this case, the user may first paint on a very thin coat of SuperClear Table Top Epoxy, allowing that to set before pouring the new layer.

To better ensure the safety of your goods, professional, environmentally friendly, convenient and efficient packaging services will be provided.