Electronic Car Window Smart Tint, Electric Tint Glass Film

Electronic Car Window Smart Tint, Electric Tint Glass Film

Product:	Car window tinting film
Product NAME	window Film
Size/roll:	1.52(width)x30(length)m
Weight:	10kg
Materials:	High-performance PET
Thickness:	2mil
Visible light Transmittance:	1%- 70%
IR Transmittance:	1%-   50%
Ultraviolet Transmittance:	1%_70%
Reflective:	No
Stand up against:	Water, dirt, grease, salt, weak acids oil
Heat resistant:	-30 to 300 degree
Layers:	2 Layers: window film, Protection film
Application:	for side and rear window

- Heat insulation
- Colored for privacy protection

- Remove fogging caused by rain, snow humidity

- Keep sign clean for safe driving

Tools For Wrapping :

Snap-Off Blade Knife, Straightedge, Triangle hard scraper, Soft Squeegee, Sprayer

1. Film Cutting .

Cut Paper Pattern on outside glass. Trim film to fit that paper pattern.

2. Make soapy water solution

Mix 5-10 drops detergent with 500g water in Sprayer. Well-proportioned them by shake the sprayer up and down.

3. Clean window

Spray soapy water on glass and scraping the glass by soft squeegee. From top to bottom or left to right. Do it again by 2-3 times. (Make sure the glass is clean)

4. Separate film from liner .

Peel film apart from backing. Spraying water on adhesive while peeling just to prevent films sticking together.

5. Place film on glass .

Spray some soapy water on adhesive and glass. Then place film on glass to the exact place. (More soapy water, easier to move film during installation).

6. Scrapping

Spray soapy water solution on film surface and squeegee firmly to wipe out all the water.

The liner can be put on the film during scrapping to prevent film from scratching.

It should be scrapped from middle to both sides. Lightly scrap at first, squeegee firmly after the film is fixed on the glass.

The scrapping will be finished once all water wiped out.

7. Trim film with new sharp blade, leaving 1/16” gap around edges

8. Drying time 3 days in full sun